You are here:

Detecting Differential Speededness in Multistage Testing
ARTICLE

, , ,

Journal of Educational Measurement Volume 44, Number 2, ISSN 0022-0655

Abstract

A potential undesirable effect of multistage testing is differential speededness, which happens if some of the test takers run out of time because they receive subtests with items that are more time intensive than others. This article shows how a probabilistic response-time model can be used for estimating differences in time intensities and speed between subtests and test takers and detecting differential speededness. An empirical data set for a multistage test in the computerized CPA Exam was used to demonstrate the procedures. Although the more difficult subtests appeared to have items that were more time intensive than the easier subtests, an analysis of the residual response times did not reveal any significant differential speededness because the time limit appeared to be appropriate. In a separate analysis, within each of the subtests, we found minor but consistent patterns of residual times that are believed to be due to a warm-up effect, that is, use of more time on the initial items than they actually need.

Citation

van der Linden, W.J., Breithaupt, K., Chuah, S.C. & Zhang, Y. (2007). Detecting Differential Speededness in Multistage Testing. Journal of Educational Measurement, 44(2), 117-130. Retrieved March 28, 2024 from .

This record was imported from ERIC on April 18, 2013. [Original Record]

ERIC is sponsored by the Institute of Education Sciences (IES) of the U.S. Department of Education.

Copyright for this record is held by the content creator. For more details see ERIC's copyright policy.

Keywords